| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A flaw was found in libsoup, where the soup_message_headers_get_content_disposition() function is vulnerable to a NULL pointer dereference. This flaw allows a malicious HTTP peer to crash a libsoup client or server that uses this function. |
| Tanium addressed a denial of service vulnerability in Enforce. |
| In the Linux kernel, the following vulnerability has been resolved:
keys: Check the authorization payload in process keyring searches
An authorization payload and its saved credentials must remain valid
while search_process_keyrings_rcu() searches the requestor's keyrings.
The function validates the authorization key, then separately loads
payload.data[0] and unconditionally reads rka->cred. Validation does
not prevent request_key_auth_revoke() from clearing the payload.
A request-key helper can assume authority and fork a descendant that
inherits the authorization key. If the descendant misses in its own
keyrings, it falls back to the saved requestor credentials. Successful
target instantiation invalidates the authorization key without clearing
the payload. After the helper exits, UMH_WAIT_PROC returns to the
requester, which calls complete_request_key() and revokes that key.
With the descendant paused after validation, the paths can interleave
as follows:
1. The descendant enters search_process_keyrings_rcu() under RCU and
key_validate() succeeds.
2. The helper instantiates the target, invalidates the authorization
key, and exits.
3. The requester resumes from UMH_WAIT_PROC, calls
complete_request_key(), and revokes the authorization key.
request_key_auth_revoke() sets its payload pointer to NULL.
4. The descendant loads NULL and dereferences rka->cred.
This NULL dereference can oops the kernel. RCU delays payload disposal
but does not prevent the pointer from being cleared.
Load the payload with dereference_key_rcu() and require a non-NULL
result before validating the authorization key and searching its saved
credentials. A non-NULL payload and its credentials remain alive for
the caller's RCU read-side section; a cleared payload skips the fallback
search and follows the existing error selection.
KASAN report as below:
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000005: 0000 [#1] SMP KASAN NOPTI
KASAN: null-ptr-deref in range [0x0000000000000028-0x000000000000002f]
RIP: 0010:search_process_keyrings_rcu+0x32b/0x790 |
| RAOP module accepts unbounded Content-Length values and does not check the pw_array_add() return. |
| A null pointer dereference was addressed with improved input validation. This issue is fixed in iOS 27 and iPadOS 27, macOS Golden Gate 27, macOS Tahoe 26.7.2, tvOS 27, visionOS 27, watchOS 27. An app may be able to cause unexpected system termination. |
| In Eclipse ThreadX NetX Duo versions 6.4.0 through 6.5.2.202603a, built with VLAN and SRP support, evicting the last attribute in an MRP participant's list writes through a null successor pointer. An unauthenticated station on the same Layer 2 segment can fault the MRP worker thread by declaring one MSRP attribute and withdrawing it, and ordinary withdrawals by legitimate stations reach the same path. |
| In Eclipse ThreadX NetX Duo versions 6.4.0 through 6.5.2.202603a, built with VLAN and SRP support, the MSRP attribute lookup writes through the null pointer returned by its allocator when the ten-entry attribute table is full. An unauthenticated station on the same Layer 2 segment can fault the MRP worker thread by declaring enough new attributes, and Talker Failed declarations hold table entries that are never released. |
| A flaw was found in the H.264 video parser in gst-plugins-bad. When processing a specially crafted H.264 video file or network stream with malformed Multiview (MVC) Sequence Parameter Set data, the parser can dereference a NULL pointer during the cleanup of partially allocated internal structures after a parse failure. This can cause the application using GStreamer to crash, resulting in a denial of service. |
| A null pointer dereference was addressed with improved validation. This issue is fixed in iOS 26.7.2 and iPadOS 26.7.2, iOS 27.2 and iPadOS 27.2, macOS Golden Gate 27.2, macOS Tahoe 26.7.2, tvOS 27.2, visionOS 27.2, watchOS 27.2. An attacker in physical proximity may be able to cause a denial-of-service. |
| The OCPP 1.6 client in subsys/net/lib/ocpp/ocpp.c reconstructs a session handle and PDU id from the uid field of a CALLRESULT message. In ocpp_process_server_msg() the code calls atoi(strtok_r(uid, "-", &tmp)) without checking the strtok_r return value. When the server-supplied uid is empty or contains no - delimiter, strtok_r() returns NULL and atoi(NULL) dereferences a NULL pointer, which is undefined behaviour.
The uid originates from network data: parse_rpc_msg() in subsys/net/lib/ocpp/ocpp_j.c JSON-parses a frame received from the OCPP central system over TCP/WebSocket and copies the server-controlled string into the local buffer. A malicious or compromised central system, or a man-in-the-middle on a non-TLS ws:// connection, can return a malformed uid to reach the defect. No authentication beyond the existing server connection (or MITM position) is required, and the reconstructed pointer is membership-validated by ocpp_session_is_valid(), so the impact is limited to the NULL dereference rather than arbitrary pointer use.
On Zephyr targets that trap access to address 0 (MMU/MPU platforms or CONFIG_NULL_POINTER_EXCEPTION_DETECTION), the dereference faults inside the OCPP reader thread and invokes the fatal handler, producing a remote denial of service of the charge point; on bare targets where address 0 is readable the call returns 0 and is benign, so the impact is availability-only and platform-conditional.
The applied fix guards only the first atoi(); the second strtok_r(NULL, "-", &tmp) followed by pdu = atoi(buf) in the same function remains unguarded and the identical NULL dereference is still reachable from the same network input when the uid has a first token but no second --delimited token. A complete fix should validate the second token as well. |
| The MCTP-over-I2C+GPIO target binding in subsys/pmci/mctp/mctp_i2c_gpio_target.c emulates a small pseudo-register file, where the bus controller first writes a register number and then writes or reads payload bytes. The selected register (b->reg_addr) and the data-phase flag (b->rxtx) were never cleared when the controller issued an I2C STOP, so after a completed transfer the target still had a data register selected while the packet buffer that register refers to had already been consumed and set to NULL by mctp_i2c_gpio_target_stop().
A controller on the bus can re-enter the same branch of mctp_i2c_gpio_target_stop() with a NULL buffer using two ordinary transactions and no authentication: first a normal packet write to MCTP_I2C_GPIO_RX_MSG_ADDR followed by STOP (which delivers and frees b->rx_pkt), then a bare read transaction followed by STOP. The failing read_requested() call leaves the stale state untouched and the I2C driver still delivers the STOP callback, which then calls mctp_bus_rx() with a NULL packet. The symmetric case exists on the transmit side, where the stale MCTP_I2C_GPIO_TX_MSG_ADDR selection dereferences b->tx_pkt->end after b->tx_pkt has been cleared and additionally signals b->tx_complete a second time, causing the next outbound packet to be dropped.
The dereference happens in the I2C target interrupt handler, so on any target that traps accesses to address 0 the result is a fatal exception and a device reset or halt — a denial of service inflicted by any device able to act as controller on the shared management bus (for example compromised firmware on a peer MCTP endpoint or on the BMC). On parts where address 0 is readable, the impact degrades to a malformed packet buffer being handed to the MCTP stack and lost transmit packets. No attacker-controlled value is written and no confidentiality or integrity boundary is crossed.
The fix resets b->reg_addr to MCTP_I2C_GPIO_INVALID_ADDR and clears b->rxtx at every STOP, so a new register must be selected before any data phase can run again. Only builds that opt into the experimental CONFIG_MCTP subsystem with CONFIG_MCTP_I2C_GPIO_TARGET=y are affected. |
| The Zephyr Bluetooth LE Audio Basic Audio Profile (BAP) unicast client mishandles peer-supplied ASE state notifications. In unicast_client_ep_qos_state() (subsys/bluetooth/audio/bap_unicast_client.c), the handler writes attacker-controlled QoS fields (interval, framing, phy, sdu, rtn, latency, pd) through the stream->qos pointer with only a stream != NULL guard. stream->qos is NULL for any stream that has been codec-configured via bt_bap_stream_config() but not yet added to a unicast group (it is set only by unicast_group_add_stream()).
A malicious or buggy remote ASCS server, to which the local device is connected as a BAP unicast client, can send a GATT notification announcing the ASE has entered the QoS Configured state while the local endpoint is still in the Codec Configured state — a transition the dispatcher explicitly permits — during that window, causing a write through a NULL pointer and a crash (denial of service). The data written is itself remote-controlled.
The defect shipped in v4.3.0 and v4.4.0 (and earlier). The fix re-points all BAP QoS storage to the always-valid embedded ep->qos struct, eliminating the NULL dereference. |
| A NULL pointer dereference flaw was found in 389-ds-base. This flaw occurs when a ModifyDN (rename) operation uses an attribute's schema alias name (such as "commonName") instead of its canonical name (such as "cn") as the new relative distinguished name. An authenticated attacker with the ModifyDN (rename) permission on the affected entry can use this flaw to crash the directory server, causing a denial of service. |
| In BuildKit versions v0.26.0 through v0.34.1, a specific build definition that resolves metadata for the same Git source reference twice can cause the BuildKit daemon to panic and crash, interrupting builds handled by that daemon. The issue is fixed in v0.34.2. |
| NULL Pointer Dereference in GitHub repository gpac/gpac prior to 1.1.0. |
| A NULL pointer dereference vulnerability has been reported to affect several QNAP operating system versions. The remote attackers can then exploit the vulnerability to launch a denial-of-service (DoS) attack.
We have already fixed the vulnerability in the following versions:
QTS 5.2.7.3297 build 20251024 and later
QuTS hero h5.2.7.3297 build 20251024 and later
QuTS hero h5.3.1.3292 build 20251024 and later |
| HDF5 through 2.2.0 contains a NULL pointer dereference vulnerability in H5HL_unprotect() in src/H5HL.c. H5HL_protect() pins a single metadata cache entry for a local heap, either the heap prefix or the separate data block, and H5HL_unprotect() unpins it on the final unprotect. When the metadata cache destroys a corrupted local heap entry, H5HL__prfx_dest() unlinks it from the heap by setting heap->prfx or heap->dblk to NULL. A crafted HDF5 file can therefore reach H5HL_unprotect() with no cached object to unpin, and the function passes the NULL pointer to H5AC_unpin_entry(). This causes an assertion failure in debug builds and a NULL pointer dereference and crash in release builds. An attacker who can get a user or application to open and traverse a malicious file can cause a denial of service. |
| The GridFS file download API in the MongoDB C Driver does not check the result of an internal operation under certain error conditions during file retrieval. This can cause the process to terminate when stream operations continue. A user who can influence file download parameters can trigger this condition, which may result in service unavailability for applications using the affected API. |
| In the Linux kernel, the following vulnerability has been resolved:
asymmetric_keys: reject trust keys without IDs
The PKCS#8 parser deliberately leaves the asym_key_ids payload slot
empty. key_or_keyring_common() unconditionally dereferences that slot
when a PKCS#8 key is supplied to a key_or_keyring restriction. Both the
plain and :chain forms reach this branch, allowing an unprivileged caller
to trigger a NULL pointer dereference through KEYCTL_RESTRICT_KEYRING
followed by add_key().
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
RIP: 0010:key_or_keyring_common (crypto/asymmetric_keys/restrict.c:205 crypto/asymmetric_keys/restrict.c:279)
Call Trace:
<TASK>
__key_create_or_update (security/keys/key.c:884)
key_create_or_update (security/keys/key.c:1021)
__do_sys_add_key (security/keys/keyctl.c:134)
do_syscall_64 (arch/x86/entry/common.c:52 arch/x86/entry/common.c:83)
entry_SYSCALL_64_after_hwframe (arch/x86/entry/entry_64.S:130)
</TASK>
Kernel panic - not syncing: Fatal exception
Reject an asymmetric restriction key without key IDs. A PKCS#8 private
key cannot identify the signer of a candidate certificate and is not a
valid trust anchor. |
| A null pointer dereference was addressed with improved validation. This issue is fixed in iOS 26.7.2 and iPadOS 26.7.2, iOS 27.2 and iPadOS 27.2. An attacker in physical proximity may be able to cause a denial-of-service. |
